Conceal Shower Set

Connect the two elbow joints
(1) After wrapping the raw material tape, use an adjustable wrench to tighten it on the water outlet joints in the two installation holes on the wall. After tightening, ensure that the center distance of the two elbow joints is 150mm. Put the two decorative covers
(2) Sleeve on the elbow joint; install the washer
(3) Insert into the elbow joint, use a wrench to install the nut

(4) Tighten the two elbow joints J to fix the faucet on the wall. First measure the length of the shower head, and drill three holes with a diameter of 6 mm and a depth of 35 mm at the half of the length of the shower above the outlet of the faucet. Before drilling, wrap the faucet with cloth to prevent the faucet from being soiled or damaged. Insert expansion pipes into the drilled holes respectively, and fix the wall seat on the wall with self-tapping screws. At this time, it must be noted that the wall seat must be on the same centerline as the outlet joint of the faucet. Insert the sealing ring C into the lower end A of the switching valve. Tighten the lower end A of the switching valve and the upper end B of the faucet through the thread. Before drilling, wrap the faucet with cloth 9 to prevent the faucet from being soiled and bumped. Note: When tightening with a wrench, be careful not to damage the electroplating surface.

The hidden shower system has a novel style and is very popular. The above is the relevant content of the hidden shower introduced by the editor. The hidden shower has many advantages, and the water output is relatively scattered and relatively fine. Many of our families prefer the type of hidden shower system, which is simple, without too much decoration, simple and beautiful.